A Very High Temperature Reactor (VHTR) is one of the next generation nuclear systems. From a view point of safety characteristics, a passive cooling system should be designed as the best way of a reactor vessel cooling system (VCS) in the VHTR. Therefore, the gas cooling system with natural circulation is considered as a candidate for the VCS of the VHTR. Japan Atomic Energy Agency (JAEA) is advancing the technology development of the VHTR and is now pursuing design and development of commercial systems such as the 300MWe gas turbine high temperature reactor GTHTR300C (Gas Turbine High Temperature Reactor 300 for Cogeneration). In the VCS of the GTHTR300C, many rectangular flow channels are formed around the reactor pressure vessel (RPV), and a cooling panel utilizing natural convection of air has been proposed. In order to apply the proposed panel to the VCS of the GTHTR300C, it is necessary to clarify the heat transfer and flow characteristics of the proposed channel in the cooling panel. Thus, we carried out an experiment to investigate heat transfer and fluid flow characteristics by natural convection in a vertical rectangular channel heated on one side. Experiments were also carried out to investigate the heat transfer and fluid flow characteristics by natural convection when a porous material with high porosity is inserted into the channel. An experimental apparatus is a vertical rectangular flow channel with a square cross section in which one surface is heated by a rubber heater. Dimensions of the experimental apparatus is 600 mm in height and 50 mm on one side of the square cross section. Air was used as a working fluid and fine copper wire (diameter: 0.5 mm) was used as a porous material. The temperature of the wall surface and gas in the channel were measured by K type thermocouples. We measured the outlet flow rate by hot-wire anemometer which is an omnidirectional spherical probe of diameter 2.5mm. The experiment has been carried out under the condition that a copper wire with a scourer model and a cubic lattice model were inserting into the channel. The numerical analysis used commercial CFD code. The temperature distribution of air in the vertical rectangular channel was obtained using a commercially available analysis code PHOENICS. This analysis took the thermal radiation into consideration between the heated surface and cooled surface. The analysis took the buoyancy into consideration. The physical properties of the solid took the temperature dependence into consideration. The physical properties of the fluid took the temperature and pressure dependence into consideration. In this paper we described the heat transfer coefficient and the amount of the removed heat in the proposed channel. From the results obtained in the experiment, it was found that the amount of removed heat decreased with increasing of temperature of gas when a copper wire was inserted into the channel with high porosity. This is because the mass flow rate decreased with increasing of viscosity of gas. Since it is expected that the porosity of a porous material will have an optimum value, further studies will be needed. To apply to the VHTR such as GTHTR300C, the research on the passive cooling system design is required. This study is to refer to make design of the passive cooling system for the VCS.


ICONE Competition - ICONE28-POWER2020-16705: Heat Transfer and Fluid Flow Characteristic of One Side Heated Vertical Rectangular Channel That Inserted Thin Metallic Wire

Division / Sponsors: 
Power Division & Nuclear Engineering Division (NED)

Power Conference
Paper Proceedings: https://asmedigitalcollection.asme.org/POWER/POWER2020/volume/83747

International Conference on Nuclear Engineering
Paper Proceedings: https://asmedigitalcollection.asme.org/ICONE/ICONE2020/volume/83761

POWER-ICONE - Virtual Conference

Supporting the need among researchers worldwide for additional online and multimedia content, ASME now offers the ASME Conference Video Collection. This platform will collect and provide long-term access to conference presentation videos, encompassing all technology areas within ASME's technical conference and events program. About 30,000-40,000 engineers across all mechanical engineering and related disciplines participate in ASME conferences each year. This includes authors of approximately 6,000 to 8,000 technical papers published by ASME, the majority of whom also submit video presentations for our virtual conferences. The video collection will be available as an add-on to existing product packages or as a separate subscription.