A fuel and engine management system have been successively applied to a 4.5L spark-ignition gaseous-fueled engine used for stationary power generation applications up to 50 kW. The system operates on low-pressure commercial grade natural gas or liquid propane gas and governs engine speed at either 1500 or 1800 rpm, for generator frequencies of 50 Hz and 60 Hz respectively. The fuel and engine management system consist of an engine control module, an electronically controlled fuel mixer, a fuel pressure sensor, and other supporting sensors/actuators. This new system replaces a legacy of fixed-orifice metering or vacuum-actuated-valve mechanical mixer designs. This new system allows for closed-loop control of stoichiometric combustion that meets both performance and emissions requirements without the need for a fuel pressure regulator within the genset frame. It also allows a single fuel system assembly to be used on all 4.5L engines regardless of fuel type (LP/NG) or nominal speed (50/60Hz), as these are now selected with standard J1939 CAN protocol messages from the genset controller. This paper reviews the development aspects for the new fuel system on the 4.5L engine.

The electronic-actuated fuel mixer system offers a wider range of fuel flow control compared to mechanical-actuated mixers, this results in better air-fuel control due to variations in fuel quality, low fuel supply pressure and changing ambient conditions. The range of fuel control is result of the different mixer valve construction and control. The fuel metering valve is a butterfly type and is controlled form a stepper motor. The valve controls the fuel flow rate just before the fuel mixes with the combustion air passing thought venturi. Lag in fuel flow, typical of low supply pressure and low restriction or signal ventrui, is corrected for using a feedforward control strategy based on genset electrical load. The mixer sizing and flow bench measurements for calibration, will be reviewed.

The ECM uses a speed-density air flow model, along with fuel supply and air filter pressure, to determine the best mixer valve position. The engine air flow model is used for determine venturi flow and resulting mixer vacuum signal, but a final calibration correction was created with hot wire-anemometer-flow meters on a running engine. A long-term fuel trim is also applied to the mixer position, but unlike a fuel-injection system which corrects volumetric efficiency based on known fuel flow rate and HEGO feedback, this mixer control strategy learns a steady-state mixer correction or offset. The entire strategy was developed within a Simulink model and autocode generation tools were used to create final ECM code. The development of the mixer and ECM control strategy will be detailed herein.


Fuel and Engine Management System for Gaseous-Fueled Spark-Ignition Non-Road Engines

Division / Sponsors: 
Internal Combustion Engine Division (ICED)

Paper Proceedings: https://asmedigitalcollection.asme.org/ICEF/ICEF2020/volume/84034

ICEF2020 - Virtual Conference

Supporting the need among researchers worldwide for additional online and multimedia content, ASME now offers the ASME Conference Video Collection. This platform will collect and provide long-term access to conference presentation videos, encompassing all technology areas within ASME's technical conference and events program. About 30,000-40,000 engineers across all mechanical engineering and related disciplines participate in ASME conferences each year. This includes authors of approximately 6,000 to 8,000 technical papers published by ASME, the majority of whom also submit video presentations for our virtual conferences. The video collection will be available as an add-on to existing product packages or as a separate subscription.